System Views

Changing system views changes the graphical overlay displayed in the Workspace. Each Application Mode has a specific set of System Views that can be accessed from the views drop-down to accomplish a specific task. Most views can be accessed from any mode so changing a mode is not required to access parameters. In Show Mode, the views become read only to prevent accidental changes.

To change the system view, select the drop-down arrow next to the active view and select a new view.

The following list represents all available system views within the various modes in Performance, select any System View image for more information.

View	Shortcut	Mode Used	Description
	H	Design	Add devices to the workspace and set device HControl IDs.
	P	Design, Tune	Change speaker presets, speaker crossover, and subwoofer orientation.
	M	Design, Test, Tune, Show	Toggle the mute state of devices.
	A	Show	Provides a high level aggregate amplifier fault state.
	C	Tune	Apply and adjust Array Calibration filters.
	D	Tune	Adjust speaker delay values.
	E	Tune	Adjust user EQ filters.
	G	Tune	Adjust device gain levels.
	I	Test, Tune, Show	Displays audio input levels at the array or device level.
	L	Show	Reports measured amplifier load.
	O	Test, Tune, Show	Displays audio output levels at the array or device level.
	Y	Tune	Provides device level polarity toggle controls.
	T	Show	Displays current amplifier temperature.
	V	Show	Display current amplifier input voltage.